Hi guys! Sorry I’ve been MIA for the past week! I’ve been in California on a week long DIY marathon! We gave my mom’s bonus room a much needed makeover; it has been pink and green, complete with a pink ceiling fan since I was in elementary school. We made some awesome 10 foot curtain rods for about $2 a piece (I will post that on Wednesday when I get home from CA), we have updated lamps, ceiling fans, and my Nana’s old bedroom furniture! And tomorrow we’re gonna demo my sister’s walk in closet and completely rework the whole thing! So what I’m trying to say is, we have been a VERY busy family! 😃
Now to get to the good stuff… We are in the process of turning my sister’s spare bedroom into a super cute LuLaRoe show room!
Check her shop out here: https://m.facebook.com/groups/1066414580113455/
She wanted a shiplap accent wall, but didn’t want to deal with the hassel and the cost of installing true shiplap, so we had to get creative! we decided to use 3/8 inch plywood instead of pine. We did this for several reasons. First being cost. One 4×8 foot sheet of plywood only costs about $11. Second being convenience. Plywood is thinner than your baseboards and mouldings, so you don’t have to rip off all your trim to install it. This is going to make your life exponentially easier!
Before you get started, measure your wall and come up with a plan! You are going to be cutting your sheet of plywood into boards, so decide how wide you want your boards to be. We decided that 4″ wide boards would look best in our room. After that, decide how long you want each board to be. Take into consideration what board lengths will be best given the length of your wall. Choose a length that will cause the least amount of waste. Wasted wood is wasted money! We chose 4 and 6 foot long strips and staggered the seams. Once you have decided, start measuring, marking, and cutting! Measure and mark carefully so you don’t make mistakes and waste.If you’re going to paint your boards various colors, cut first and paint after. If you want them all the same color, it would be most efficient to paint before you cut. We painted after we cut because, as you can see in the pictures, we wanted a multi colored wall. Once you get all your boards cut and painted, you can begin to install! I can’t stress this enough, planning is the most important part of your project! Measure and mark your wall before you start nailing your boards up.It’s kind of hard to see, but we marked lines on the wall where we wanted our seams so be staggered. We used a finishing nailer to attach the boards to the wall. We used two nails on each end and 2 nails in the middle of each board. There’s no need to go crazy with your nail gun.Keep on going…And going…And going…And then take a step back and admire your beautiful work!!